#include "arduino.hpp"
#include "board.h"
/*
  Arduino Hello-World @ RIOT
  Prints 'Hello Arduino!' once on the serial port during startup, toggles the
  default LED twice each seconds and echoes incoming characters on the serial
  port.
 */

// Per convention, RIOT defines a macro that is assigned the pin number of an
// on-board LED. If no LED is available, the pin number defaults to 0. For
// compatibility with the Arduino IDE, we also fall back to pin 0 here, if the
// RIOT macro is not available
#ifndef ARDUINO_LED
#define ARDUINO_LED     (0)
#endif

// For some boards RIOT defines a macro assigning the required baudrate of the
// serial link. If this macro is not set, the default baudrate is set to
// 115200.
#ifdef UART_STDIO_BAUDRATE
#define SERIAL_BAUDRATE UART_STDIO_BAUDRATE
#else
#define SERIAL_BAUDRATE 115200
#endif

// Assign the default LED pin
int ledPin = ARDUINO_LED;

// input buffer for receiving chars on the serial port
int buf[64];

// counter that counts the number of received chars
int count = 0;

void setup(void)
{
    // configure the LED pin to be output
    pinMode(ledPin, OUTPUT);
    // configure the first serial port to run with the previously defined
    // baudrate
    Serial.begin(SERIAL_BAUDRATE);
    // say hello
    Serial.println("Hello Arduino!");
}

void loop(void)
{
    // toggle the LED
    digitalWrite(ledPin, !digitalRead(ledPin));
    // test if some chars were received
    while (Serial.available() > 0) {
        // read a single character
        int tmp = Serial.read();
        // if we got a line end, we echo the buffer
        if (tmp == '\n') {
            // start with printing 'ECHO: '
            Serial.write("Echo: ");
            // echo the buffer
            for (int i = 0; i < count; i++) {
                Serial.write(buf[i]);
            }
            // terminate the string with a newline
            Serial.write('\n');
            // reset the count variable
            count = 0;
        }
        // else we just remember the incoming char
        else {
            buf[count++] = tmp;
        }
    }
    // wait for half a second
    delay(500);
}

int main(void)
{
    /* run the Arduino setup */
    setup();
    /* and the event loop */
    while (1) {
        loop();
    }
    /* never reached */
    return 0;
}