/* ---------------------------------------------------------------------------- * SAM Software Package License * ---------------------------------------------------------------------------- * Copyright (c) 2012, Atmel Corporation * * All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following condition is met: * * - Redistributions of source code must retain the above copyright notice, * this list of conditions and the disclaimer below. * * Atmel's name may not be used to endorse or promote products derived from * this software without specific prior written permission. * * DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF * MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE * DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, * OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF * LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING * NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, * EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. * ---------------------------------------------------------------------------- */ #ifndef _SAM3XA_TC1_INSTANCE_ #define _SAM3XA_TC1_INSTANCE_ #ifdef __cplusplus extern "C" { #endif /* ========== Register definition for TC1 peripheral ========== */ #if (defined(__ASSEMBLY__) || defined(__IAR_SYSTEMS_ASM__)) #define REG_TC1_CCR0 (0x40084000U) /**< \brief (TC1) Channel Control Register (channel = 0) */ #define REG_TC1_CMR0 (0x40084004U) /**< \brief (TC1) Channel Mode Register (channel = 0) */ #define REG_TC1_SMMR0 (0x40084008U) /**< \brief (TC1) Stepper Motor Mode Register (channel = 0) */ #define REG_TC1_CV0 (0x40084010U) /**< \brief (TC1) Counter Value (channel = 0) */ #define REG_TC1_RA0 (0x40084014U) /**< \brief (TC1) Register A (channel = 0) */ #define REG_TC1_RB0 (0x40084018U) /**< \brief (TC1) Register B (channel = 0) */ #define REG_TC1_RC0 (0x4008401CU) /**< \brief (TC1) Register C (channel = 0) */ #define REG_TC1_SR0 (0x40084020U) /**< \brief (TC1) Status Register (channel = 0) */ #define REG_TC1_IER0 (0x40084024U) /**< \brief (TC1) Interrupt Enable Register (channel = 0) */ #define REG_TC1_IDR0 (0x40084028U) /**< \brief (TC1) Interrupt Disable Register (channel = 0) */ #define REG_TC1_IMR0 (0x4008402CU) /**< \brief (TC1) Interrupt Mask Register (channel = 0) */ #define REG_TC1_CCR1 (0x40084040U) /**< \brief (TC1) Channel Control Register (channel = 1) */ #define REG_TC1_CMR1 (0x40084044U) /**< \brief (TC1) Channel Mode Register (channel = 1) */ #define REG_TC1_SMMR1 (0x40084048U) /**< \brief (TC1) Stepper Motor Mode Register (channel = 1) */ #define REG_TC1_CV1 (0x40084050U) /**< \brief (TC1) Counter Value (channel = 1) */ #define REG_TC1_RA1 (0x40084054U) /**< \brief (TC1) Register A (channel = 1) */ #define REG_TC1_RB1 (0x40084058U) /**< \brief (TC1) Register B (channel = 1) */ #define REG_TC1_RC1 (0x4008405CU) /**< \brief (TC1) Register C (channel = 1) */ #define REG_TC1_SR1 (0x40084060U) /**< \brief (TC1) Status Register (channel = 1) */ #define REG_TC1_IER1 (0x40084064U) /**< \brief (TC1) Interrupt Enable Register (channel = 1) */ #define REG_TC1_IDR1 (0x40084068U) /**< \brief (TC1) Interrupt Disable Register (channel = 1) */ #define REG_TC1_IMR1 (0x4008406CU) /**< \brief (TC1) Interrupt Mask Register (channel = 1) */ #define REG_TC1_CCR2 (0x40084080U) /**< \brief (TC1) Channel Control Register (channel = 2) */ #define REG_TC1_CMR2 (0x40084084U) /**< \brief (TC1) Channel Mode Register (channel = 2) */ #define REG_TC1_SMMR2 (0x40084088U) /**< \brief (TC1) Stepper Motor Mode Register (channel = 2) */ #define REG_TC1_CV2 (0x40084090U) /**< \brief (TC1) Counter Value (channel = 2) */ #define REG_TC1_RA2 (0x40084094U) /**< \brief (TC1) Register A (channel = 2) */ #define REG_TC1_RB2 (0x40084098U) /**< \brief (TC1) Register B (channel = 2) */ #define REG_TC1_RC2 (0x4008409CU) /**< \brief (TC1) Register C (channel = 2) */ #define REG_TC1_SR2 (0x400840A0U) /**< \brief (TC1) Status Register (channel = 2) */ #define REG_TC1_IER2 (0x400840A4U) /**< \brief (TC1) Interrupt Enable Register (channel = 2) */ #define REG_TC1_IDR2 (0x400840A8U) /**< \brief (TC1) Interrupt Disable Register (channel = 2) */ #define REG_TC1_IMR2 (0x400840ACU) /**< \brief (TC1) Interrupt Mask Register (channel = 2) */ #define REG_TC1_BCR (0x400840C0U) /**< \brief (TC1) Block Control Register */ #define REG_TC1_BMR (0x400840C4U) /**< \brief (TC1) Block Mode Register */ #define REG_TC1_QIER (0x400840C8U) /**< \brief (TC1) QDEC Interrupt Enable Register */ #define REG_TC1_QIDR (0x400840CCU) /**< \brief (TC1) QDEC Interrupt Disable Register */ #define REG_TC1_QIMR (0x400840D0U) /**< \brief (TC1) QDEC Interrupt Mask Register */ #define REG_TC1_QISR (0x400840D4U) /**< \brief (TC1) QDEC Interrupt Status Register */ #define REG_TC1_FMR (0x400840D8U) /**< \brief (TC1) Fault Mode Register */ #define REG_TC1_WPMR (0x400840E4U) /**< \brief (TC1) Write Protect Mode Register */ #else #define REG_TC1_CCR0 (*(WoReg*)0x40084000U) /**< \brief (TC1) Channel Control Register (channel = 0) */ #define REG_TC1_CMR0 (*(RwReg*)0x40084004U) /**< \brief (TC1) Channel Mode Register (channel = 0) */ #define REG_TC1_SMMR0 (*(RwReg*)0x40084008U) /**< \brief (TC1) Stepper Motor Mode Register (channel = 0) */ #define REG_TC1_CV0 (*(RoReg*)0x40084010U) /**< \brief (TC1) Counter Value (channel = 0) */ #define REG_TC1_RA0 (*(RwReg*)0x40084014U) /**< \brief (TC1) Register A (channel = 0) */ #define REG_TC1_RB0 (*(RwReg*)0x40084018U) /**< \brief (TC1) Register B (channel = 0) */ #define REG_TC1_RC0 (*(RwReg*)0x4008401CU) /**< \brief (TC1) Register C (channel = 0) */ #define REG_TC1_SR0 (*(RoReg*)0x40084020U) /**< \brief (TC1) Status Register (channel = 0) */ #define REG_TC1_IER0 (*(WoReg*)0x40084024U) /**< \brief (TC1) Interrupt Enable Register (channel = 0) */ #define REG_TC1_IDR0 (*(WoReg*)0x40084028U) /**< \brief (TC1) Interrupt Disable Register (channel = 0) */ #define REG_TC1_IMR0 (*(RoReg*)0x4008402CU) /**< \brief (TC1) Interrupt Mask Register (channel = 0) */ #define REG_TC1_CCR1 (*(WoReg*)0x40084040U) /**< \brief (TC1) Channel Control Register (channel = 1) */ #define REG_TC1_CMR1 (*(RwReg*)0x40084044U) /**< \brief (TC1) Channel Mode Register (channel = 1) */ #define REG_TC1_SMMR1 (*(RwReg*)0x40084048U) /**< \brief (TC1) Stepper Motor Mode Register (channel = 1) */ #define REG_TC1_CV1 (*(RoReg*)0x40084050U) /**< \brief (TC1) Counter Value (channel = 1) */ #define REG_TC1_RA1 (*(RwReg*)0x40084054U) /**< \brief (TC1) Register A (channel = 1) */ #define REG_TC1_RB1 (*(RwReg*)0x40084058U) /**< \brief (TC1) Register B (channel = 1) */ #define REG_TC1_RC1 (*(RwReg*)0x4008405CU) /**< \brief (TC1) Register C (channel = 1) */ #define REG_TC1_SR1 (*(RoReg*)0x40084060U) /**< \brief (TC1) Status Register (channel = 1) */ #define REG_TC1_IER1 (*(WoReg*)0x40084064U) /**< \brief (TC1) Interrupt Enable Register (channel = 1) */ #define REG_TC1_IDR1 (*(WoReg*)0x40084068U) /**< \brief (TC1) Interrupt Disable Register (channel = 1) */ #define REG_TC1_IMR1 (*(RoReg*)0x4008406CU) /**< \brief (TC1) Interrupt Mask Register (channel = 1) */ #define REG_TC1_CCR2 (*(WoReg*)0x40084080U) /**< \brief (TC1) Channel Control Register (channel = 2) */ #define REG_TC1_CMR2 (*(RwReg*)0x40084084U) /**< \brief (TC1) Channel Mode Register (channel = 2) */ #define REG_TC1_SMMR2 (*(RwReg*)0x40084088U) /**< \brief (TC1) Stepper Motor Mode Register (channel = 2) */ #define REG_TC1_CV2 (*(RoReg*)0x40084090U) /**< \brief (TC1) Counter Value (channel = 2) */ #define REG_TC1_RA2 (*(RwReg*)0x40084094U) /**< \brief (TC1) Register A (channel = 2) */ #define REG_TC1_RB2 (*(RwReg*)0x40084098U) /**< \brief (TC1) Register B (channel = 2) */ #define REG_TC1_RC2 (*(RwReg*)0x4008409CU) /**< \brief (TC1) Register C (channel = 2) */ #define REG_TC1_SR2 (*(RoReg*)0x400840A0U) /**< \brief (TC1) Status Register (channel = 2) */ #define REG_TC1_IER2 (*(WoReg*)0x400840A4U) /**< \brief (TC1) Interrupt Enable Register (channel = 2) */ #define REG_TC1_IDR2 (*(WoReg*)0x400840A8U) /**< \brief (TC1) Interrupt Disable Register (channel = 2) */ #define REG_TC1_IMR2 (*(RoReg*)0x400840ACU) /**< \brief (TC1) Interrupt Mask Register (channel = 2) */ #define REG_TC1_BCR (*(WoReg*)0x400840C0U) /**< \brief (TC1) Block Control Register */ #define REG_TC1_BMR (*(RwReg*)0x400840C4U) /**< \brief (TC1) Block Mode Register */ #define REG_TC1_QIER (*(WoReg*)0x400840C8U) /**< \brief (TC1) QDEC Interrupt Enable Register */ #define REG_TC1_QIDR (*(WoReg*)0x400840CCU) /**< \brief (TC1) QDEC Interrupt Disable Register */ #define REG_TC1_QIMR (*(RoReg*)0x400840D0U) /**< \brief (TC1) QDEC Interrupt Mask Register */ #define REG_TC1_QISR (*(RoReg*)0x400840D4U) /**< \brief (TC1) QDEC Interrupt Status Register */ #define REG_TC1_FMR (*(RwReg*)0x400840D8U) /**< \brief (TC1) Fault Mode Register */ #define REG_TC1_WPMR (*(RwReg*)0x400840E4U) /**< \brief (TC1) Write Protect Mode Register */ #endif /* (defined(__ASSEMBLY__) || defined(__IAR_SYSTEMS_ASM__)) */ #ifdef __cplusplus } #endif #endif /* _SAM3XA_TC1_INSTANCE_ */