fb11e647
 vrobic
reseau statique a...
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
|
# U8g2 Package Test
## About
This is a test application for the U8g2 package. This package is a graphical display library, including display drivers.
## Usage
This test application will initialize the U8g2 to output on one of the following:
* output to terminal virtual screen.
* output to SDL virtual screen.
* output to I2C graphics screen.
* output to SPI graphics screen.
Note: you may have to run `make clean` between different output modes.
### Output to terminal
To output to this virtual screen, supply `TEST_OUTPUT=1` to the `make` command.
### Output to SDL
To output to this virtual screen, supply `TEST_OUTPUT=2` to the `make` command.
This is a native-only option and requires SDL (32-bits) to be installed.
### Output to SPI
To output to screen, supply `TEST_OUTPUT=3` to the `make` command.
* `TEST_SPI` — The SPI device.
* `TEST_PIN_CS` — If applicable, the CS pin.
* `TEST_PIN_DC` — If applicable, the Command/Data pin.
* `TEST_PIN_RESET` — If applicable, the reset pin.
* `TEST_DISPLAY` — The used display driver (see https://github.com/olikraus/u8g2/wiki/u8g2setupc). Make sure you select a SPI compatible display.
### Output to I2C
To output to screen, supply `TEST_OUTPUT=4` to the `make` command.
Furthermore, you can configure the following:
* `TEST_I2C` — The I2C device.
* `TEST_ADDR` — The address to write commands to.
* `TEST_PIN_RESET` — If applicable, the reset pin.
* `TEST_DISPLAY` — The used display driver (see https://github.com/olikraus/u8g2/wiki/u8g2setupc). Make sure you select an I2C compatible display.
## Expected result
The output of this test depends on the output mode and used hardware. If it works, the application cycles through three screens with the text: 'This is RIOT-OS'.
|