/* * Copyright (C) 2015-2016 Freie Universität Berlin * 2016 Inria * * This file is subject to the terms and conditions of the GNU Lesser * General Public License v2.1. See the file LICENSE in the top level * directory for more details. */ /** * @ingroup drivers_cc2420 * @{ * * @file * @brief Implementation of public functions for cc2420 driver * * @author Thomas Eichinger * @author Hauke Petersen * * @} */ #include "luid.h" #include "byteorder.h" #include "net/ieee802154.h" #include "net/gnrc.h" #include "cc2420_internal.h" #include "cc2420_netdev.h" #include "cc2420_registers.h" #define ENABLE_DEBUG (0) #include "debug.h" void cc2420_setup(cc2420_t * dev, const cc2420_params_t *params) { /* set pointer to the devices netdev functions */ dev->netdev.netdev.driver = &cc2420_driver; /* pull in device configuration parameters */ memcpy(&dev->params, params, sizeof(cc2420_params_t)); dev->state = CC2420_STATE_IDLE; /* reset device descriptor fields */ dev->options = 0; } int cc2420_init(cc2420_t *dev) { uint16_t reg; uint8_t addr[8]; /* reset options and sequence number */ dev->netdev.seq = 0; dev->netdev.flags = 0; /* set default address, channel, PAN ID, and TX power */ luid_get(addr, sizeof(addr)); /* make sure we mark the address as non-multicast and not globally unique */ addr[0] &= ~(0x01); addr[0] |= 0x02; cc2420_set_addr_short(dev, &addr[6]); cc2420_set_addr_long(dev, addr); cc2420_set_pan(dev, CC2420_PANID_DEFAULT); cc2420_set_chan(dev, CC2420_CHAN_DEFAULT); cc2420_set_txpower(dev, CC2420_TXPOWER_DEFAULT); /* set default options */ cc2420_set_option(dev, CC2420_OPT_AUTOACK, true); cc2420_set_option(dev, CC2420_OPT_CSMA, true); cc2420_set_option(dev, CC2420_OPT_TELL_TX_START, true); cc2420_set_option(dev, CC2420_OPT_TELL_RX_END, true); #ifdef MODULE_NETSTATS_L2 cc2420_set_option(dev, CC2420_OPT_TELL_RX_END, true); #endif /* set default protocol*/ #ifdef MODULE_GNRC_SIXLOWPAN dev->netdev.proto = GNRC_NETTYPE_SIXLOWPAN; #elif MODULE_GNRC dev->netdev.proto = GNRC_NETTYPE_UNDEF; #endif /* change default RX bandpass filter to 1.3uA (as recommended) */ reg = cc2420_reg_read(dev, CC2420_REG_RXCTRL1); reg |= CC2420_RXCTRL1_RXBPF_LOCUR; cc2420_reg_write(dev, CC2420_REG_RXCTRL1, reg); /* set the FIFOP threshold to maximum. */ cc2420_reg_write(dev, CC2420_REG_IOCFG0, CC2420_PKT_MAXLEN); /* turn off "Security enable" (page 33). */ reg = cc2420_reg_read(dev, CC2420_REG_SECCTRL0); reg &= ~CC2420_SECCTRL0_RXFIFO_PROT; cc2420_reg_write(dev, CC2420_REG_SECCTRL0, reg); /* set preamble length to 3 leading zero byte */ /* and turn on hardware CRC generation */ reg = cc2420_reg_read(dev, CC2420_REG_MDMCTRL0); reg &= ~(CC2420_MDMCTRL0_PREAMBLE_M); reg |= CC2420_MDMCTRL0_PREAMBLE_3B; reg |= CC2420_MDMCTRL0_AUTOCRC; cc2420_reg_write(dev, CC2420_REG_MDMCTRL0, reg); /* go into RX state */ cc2420_set_state(dev, CC2420_GOTO_RX); return 0; } bool cc2420_cca(cc2420_t *dev) { while (!(cc2420_status(dev) & CC2420_STATUS_RSSI_VALID)) {} return gpio_read(dev->params.pin_cca); } size_t cc2420_send(cc2420_t *dev, const struct iovec *data, unsigned count) { size_t n = cc2420_tx_prepare(dev, data, count); if ((n > 0) && !(dev->options & CC2420_OPT_PRELOADING)) { cc2420_tx_exec(dev); } return n; } size_t cc2420_tx_prepare(cc2420_t *dev, const struct iovec *data, unsigned count) { size_t pkt_len = 2; /* include the FCS (frame check sequence) */ /* wait for any ongoing transmissions to be finished */ DEBUG("cc2420: tx_exec: waiting for any ongoing transmission\n"); while (cc2420_get_state(dev) & NETOPT_STATE_TX) {} /* get and check the length of the packet */ for (unsigned i = 0; i < count; i++) { pkt_len += data[i].iov_len; } if (pkt_len >= CC2420_PKT_MAXLEN) { DEBUG("cc2420: tx_prep: unable to send, pkt too large\n"); return 0; } /* flush TX FIFO and write new packet to it */ cc2420_strobe(dev, CC2420_STROBE_FLUSHTX); /* push packet length to TX FIFO */ cc2420_fifo_write(dev, (uint8_t *)&pkt_len, 1); /* push packet to TX FIFO */ for (int i = 0; i < count; i++) { cc2420_fifo_write(dev, (uint8_t *)data[i].iov_base, data[i].iov_len); } DEBUG("cc2420: tx_prep: loaded %i byte into the TX FIFO\n", (int)pkt_len); return pkt_len; } void cc2420_tx_exec(cc2420_t *dev) { /* trigger the transmission */ if (dev->options & CC2420_OPT_TELL_TX_START) { dev->netdev.netdev.event_callback(&dev->netdev.netdev, NETDEV_EVENT_TX_STARTED); } DEBUG("cc2420: tx_exec: TX_START\n"); if (dev->options & CC2420_OPT_CSMA) { DEBUG("cc2420: tx_exec: triggering TX with CCA\n"); cc2420_strobe(dev, CC2420_STROBE_TXONCCA); } else { DEBUG("cc2420: tx_exec: triggering TX without CCA\n"); cc2420_strobe(dev, CC2420_STROBE_TXON); } } int cc2420_rx(cc2420_t *dev, uint8_t *buf, size_t max_len, void *info) { uint8_t len; uint8_t crc_corr; /* without a provided buffer, only readout the length and return it */ if (buf == NULL) { /* get the packet length (without dropping it) (first byte in RX FIFO) */ cc2420_ram_read(dev, CC2420_RAM_RXFIFO, &len, 1); len -= 2; /* subtract RSSI and FCF */ DEBUG("cc2420: recv: packet of length %i in RX FIFO\n", (int)len); } else { /* read length byte */ cc2420_fifo_read(dev, &len, 1); len -= 2; /* subtract RSSI and FCF */ /* if a buffer is given, read (and drop) the packet */ len = (len > max_len) ? max_len : len; /* read fifo contents */ DEBUG("cc2420: recv: reading %i byte of the packet\n", (int)len); cc2420_fifo_read(dev, buf, len); uint8_t rssi; cc2420_fifo_read(dev, &rssi, 1); DEBUG("cc2420: recv: RSSI is %i\n", (int)rssi); /* fetch and check if CRC_OK bit (MSB) is set */ cc2420_fifo_read(dev, &crc_corr, 1); if (!(crc_corr & 0x80)) { DEBUG("cc2420: recv: CRC_OK bit not set, dropping packet\n"); /* drop the corrupted frame from the RXFIFO */ len = 0; } /* finally flush the FIFO */ cc2420_strobe(dev, CC2420_STROBE_FLUSHRX); cc2420_strobe(dev, CC2420_STROBE_FLUSHRX); } return (int)len; }