a752c7ab
 elopes
add first test an...
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
|
## OpenThread on RIOT
This test demonstrates the [OpenThread](https://github.com/openthread/openthread) stack running on RIOT. When flashed,
it will initialize the OpenThread Command Line Interface for interacting with the stack.
## Quick usage
To test OpenThread on RIOT, you can do the following:
1. Flash nodes with `make BOARD=<target> clean all flash`
2. Write `panid 0x1234`, `ifconfig up` then `thread start` on one node.
3. Check the state of the node with `state`. In the beggining should be `detached`, but after some seconds it should
become `leader`
4. Write `panid 0x1234`, `ifconfig up` then `thread start` on another node.
The second node should become `child` or `router` if there's a leader.
5. Get the mesh IP address of a node with `ipaddr`.
```
ipaddr
fdde:ad00:beef::ff:fe00:8000
fe80::ff:fe00:8000
fdde:ad00:beef:0:946a:c722:a5d9:8481
fe80::3984:f4eb:d182:5dae
```
Addresses starting with `fd` are mesh-local, and addresses starting with `fe80` are link-local.
Mesh-local address types that contain `ff:fe00` are classified as Router Locator (RLOC). Mesh-local address types
that don't contain `ff:fe00` are Endpoint Identifies (EID).
6. Ping from another node to a mesh-local address with `ping fdde:ad00:beef:0:946a:c722:a5d9:8481`.
7. You can try IEEE802.15.4 scan with `scan` command
8. You can also check other commands with `help`
9. Enjoy!
## Note
See the [OpenThread CLI Reference](https://github.com/openthread/openthread/blob/master/src/cli/README.md) for more information about OpenThread CLI commands
|