# About
  This is a manual test application for testing the Xbee S1 network device driver.
  
  For running this test, you need to connect the following pins of a Xbee S1
  module to your board:
  - UART RX
  - UART TX
  - VCC (3V3)
  - GND
  
  NOTE: when you use an Arduino Xbee shield, the Xbee module is connected to the
  same UART as RIOTs standard out. In this case you must redefine UART_STDIO_DEV to
  another UART interface in the board.h and connect a UART-to-USB adapter to that
  UART.
  
  # Usage
  For testing the Xbee driver you can use the netif shell commands that are
  included in this application.